Publication: Magnetic nanoparticles for removing inorganic arsenic species from waters: A proof of concept for potential application
Authors
Vicente Martínez, Yésica ; Lopez García, Ignacio ; Hernández Córdoba, Manuel ; Caravaca, Manuel ; El Farh, Sokaina
item.page.secondaryauthor
item.page.director
Publisher
Elsevier B.V.
publication.page.editor
publication.page.department
DOI
https://doi.org/10.1016/j.sampre.2023.100064
item.page.type
info:eu-repo/semantics/article
Description
© 2023 Los autores
This document is the submitted version of a published work that appeared in final form in
Advances in Sample Preparation Volume
This document is made available under the CC-BY 4.0 license http://creativecommons.org/licenses/by/4.0
To access the final edited and published work see:
https://doi.org/10.1016/j.sampre.2023.100064
Abstract
Inorganic arsenic is considered one of the most critical and severe environmental problems due to its high toxicity even at low levels of exposure, causing serious health problems. Humans can be exposed to arsenic mainly through inhalation, ingestion of food and water, especially in certain areas where water comes into contact with arsenic- bearing minerals. For natural geological reasons, water in some areas of the world may contain more arsenic than usual. For these circumstances, the development of methods for the removal of arsenic from water has been of increasing interest in recent years. This work presents an optimised removal of As(III) and As(V) from water by the in situ formation of ferrite (Fe 3 O 4 ) nanoparticles, leading to the adsorption of this element in the Fe 3 O 4 structure. In addition, the magnetic properties of the nanoparticles facilitate their removal from the medium by a magnet. The experimental conditions of the process were optimised and the total removal of high concentrations of As(III) and As(V) in water was achieved in only two minutes and at 50 °C at basic pH, using 200 μL of a 0.2 M FeCl 2 ·4H 2 O solution and 100 μL of a 0.1 M FeCl 3 ·6H 2 O solution to form Fe 3 O 4 in situ . The ferrite surface was characterised by field emission scanning electron microscopy before and after the arsenic removal process and by energy dispersive X-ray spectroscopy before the process. The study of adsorption kinetics and equilibrium isotherms reveals a Langmuir-type physicochemical process.
publication.page.subject
Citation
Advances in Sample Preparation Volume 6, May 2023, 100064
item.page.embargo
Collections
Ir a Estadísticas
Este ítem está sujeto a una licencia Creative Commons. http://creativecommons.org/licenses/by/4.0/